Introduction & recommandations
Introduction & recommandations
This manual is intended for use by the machine's service and maintenance personnel.
It also contains recommendations on transporting and moving the machine to its final location.
Before using the machine, it is recommended that the service and maintenance personnel read the operating instructions carefully in order to fully understand the operation of the mechanical elements and safety devices, as well as the risk of accidents.
The manufacturer accepts no liability for damage caused by failure to follow the instructions or by improper use of the machine. The manufacturer also reserves the right to change all components, deliverables and technical data as part of the technical development of the machine.
Symbols, indications and conventions used in this documentation
The boxes below are used throughout this manual to draw attention to important information.
Important point
Information indicated as follows is intended to draw your attention to an important point, a general remark or specific information. Failure to follow these points may result in damage to the machine, the workpieces being machined and/or stored, the tools or the machine components.
A small icon in the text 
refers to this type of fram and an explanation at the bottom of the page.
The information is either compulsory or strongly recommended.
Risk, danger
Information indicated as follows is intended to draw your attention to a risk, a danger or a critical point. These points must be understood and related situations identified in order to prevent minor or serious injury or damage to the machine, the workpieces being machined and/or stored, the tools or the machine components.
A small icon in the text 
refers to this type of frame and an explanation at the bottom of the page.
IIt is your responsibility to comply with the safety instructions, to carry out risk analyses and to put in place appropriate protective measures.
Other indications
Further information can be found in this manual. In general, the indications are based on the EN 60204-1 standards concerning the standardized colors of the functions used in the industry as well as ISO 7010 for the signaling and the safety pictograms.
You will see the following pictograms used in this manual:
Electrical hazard.
have this work carried out by professionals.
Thermal hazard, hot surface, risk of burns.
Do not use solvents or flammable and/or volatile liquids in the vicinity.
Danger of crushing, pinching, cutting.
Follow the instructions for intervention. Switch off the energy supplies. Secure the installation before starting work.
Danger related to the use of transport and handling equipment.
Use appropriate equipment and have qualified personnel perform the operation.
Danger of tipping or overturning.
Make sure the load/equipment is stable. In operation and when traveling. Check the position of the center of gravity and monitor the angle of the load.
All energy supplies must be switched off.
Follow the instructions for intervention. Switch off the energy supplies. Secure the installation before starting work.
Consult the documentation.
Follow the instructions for intervention. Switch off the energy supplies. Secure the installation before starting work..
Maneuvering prohibited.
Follow the instructions for intervention. Switch off the energy supplies. Secure the installation before starting work.
There are no comments for now.