Opening the rear cover
Opening the rear cover
On the Micro5 series 0 and 1 (up to SN/002024), the rear part of the machine consists of 2 removable parts.
From series 2 (SN/002025 onwards), the rear part is equipped with a movable cover that opens upwards, see article:
Prerequisites
The system must be powered down
Prevent the system from being restarted
Procedure
Disassembly
Rear part of the machine
Unlock the 2 right-hand locks..
Hold the cover horizontally and push it upwards
Detach the cover from the retaining screws on its left side
Remove the cover
If it is necessary to have more opening or more clearance towards the top, it is also possible to remove the upper part of the cover.
Assembly
Rear part of the machine
Offer up the cover in its position.
Engage the cover fasteners in the retaining screws on its left side.
Keep the cover horizontal and push it down.
Visually check that the fasteners are pushed in behind the retaining screws..
Lock the 2 right-hand locks..
Make sure the cover is locked and properly in place..
Electric hazard
The rear part contains electrical connections. The opening of the rear cover must be done by trained personnel and only after a complete risk analysis.
In general, always turn off all power before opening the hood
Prevent power supply (Lock-out)
Risk of crushing
The rear part has moving parts. The machine starts automatically. The paths, speed and mass of the moving parts present a danger of serious injury. The opening of the rear cover must be done by trained personnel and only after a complete risk analysis.
In general, always turn off all power before opening the hood
Prevent power supply (Lock-out)
Important
Do not open the cover while equipment is still attached. The cover is not intended to be handled or held open with an attached air intake and filtration system. Remove these systems before handling the rear cover.
There are no comments for now.