Opening the rear cover
Opening the rear cover
On the Micro5 from series 2 (SN/002025 onwards), the rear part is equipped with a movable cover that opens upwards.
For other machines, series 0 and 1 (up to SN/002024), please consult the articles:
Prerequisites
The system must be powered down.
.Prevent the system from restarting.
.The components attached to the rear cover must have been removed (air intake/filtration systems)
Procedure
Opening
Rear part of the machine
Switch off the machine and secure it against unintentional power supply..
Disconnect, disassemble and remove the air intake and filtration system
Unlock the cover and pivot it up to the highest level.
Make sure the restraint system is properly engaged before releasing the hood handle.
Closing
Rear part of the machine
With one hand, lift the cover slightly using one of the handles.
Release the restraint system and gently lower the cover to the lowest level.
Unroll the cover.
Electric hazard
The rear part contains electrical connections. The opening of the rear cover must be done by trained personnel and only after a complete risk analysis.
In general, always turn off all power before opening the hood
Prevent power supply (Lock-out)
Risk of crushing
The rear part has moving parts. The machine starts automatically. The paths, speed and mass of the moving parts present a danger of serious injury. The opening of the rear cover must be done by trained personnel and only after a complete risk analysis.
In general, always turn off all power before opening the hood
Prevent power supply (Lock-out)
Important
Do not open the cover while equipment is still attached. The cover is not intended to be handled or held open with an attached air intake and filtration system. Remove these systems before handling the rear cover.
Important
The rear cover must remain in the closed position when the machine is in use. The swivel and holding system is not designed to withstand the movements and forces generated during use of the machine.
There are no comments for now.